این سایت در حال حاضر پشتیبانی نمی شود و امکان دارد داده های نشریات بروز نباشند
Journal of Computational and Applied Research in Mechanical Engineering - JCARME، جلد ۴، شماره ۲، صفحات ۱۲۱-۱۳۲
عنوان فارسی
چکیده فارسی مقاله
کلیدواژه‌های فارسی مقاله
عنوان انگلیسی Prediction of forming limit curves (FLD, MSFLD and FLSD) and necking time for SS304L sheet using finite element method and ductile fracture criteria
چکیده انگلیسی مقاله Forming limit curves are used as a parameter in finite element analysis to control the material's level of formability. In this research, forming limit diagram (FLD) of SS304L sheet was obtained by ABAQUSfinite element software. In practice, the experimental determination of a forming limit curve is a very time-consuming procedure which requires special and expensive equipment. Forming limit diagram (FLD) is derived by the simulation of Erichsen test (out-of-plane stretching test) using hemispherical punch. There are few studies on the prediction of necking time, which is obtained by the application of Pepelnjak algorithm and ductile fracture criterion. In order for the validation, the numerical result of forming limit diagram (FLD) was compared with the experimental and analytical results and a good correlation was observed. Forming limit stress diagram (FLSD) and MSFLD were determined by plotting the principal in-plane stress and FLD corresponding to the onset of necking localization, respectively. Effect of the thickness of the sheet on forming limit curves was investigated and the results showed that increased thickness of the sheet led to raised level of the FLD and MSFLD; but, FLSD did not change considerably.
کلیدواژه‌های انگلیسی مقاله
نویسندگان مقاله کمال کلاسنگیانی |
department of mechanical engineering, ferdowsi university of mashhad, mashhad, iran
سازمان اصلی تایید شده: دانشگاه فردوسی (Ferdowsi university)

محمود شریعتی |
department of mechanical engineering, ferdowsi university of mashhad, mashhad, iran
سازمان اصلی تایید شده: دانشگاه فردوسی (Ferdowsi university)

خلیل فرهنگ دوست |
department of mechanical engineering, ferdowsi university of mashhad, mashhad, iran
سازمان اصلی تایید شده: دانشگاه فردوسی (Ferdowsi university)

نشانی اینترنتی http://jcarme.srttu.edu/article_270_ed683b1a2ee4535d1691917b36986c49.pdf
فایل مقاله فایلی برای مقاله ذخیره نشده است
کد مقاله (doi)
زبان مقاله منتشر شده en
موضوعات مقاله منتشر شده
نوع مقاله منتشر شده
برگشت به: صفحه اول پایگاه   |   نسخه مرتبط   |   نشریه مرتبط   |   فهرست نشریات