این سایت در حال حاضر پشتیبانی نمی شود و امکان دارد داده های نشریات بروز نباشند
مهندسی عمران مدرس، جلد ۱۴، شماره ۱، صفحات ۱۵۹-۱۶۷
عنوان فارسی از محلول آبی Reactive Blue بهینه سازی جذب رنگ ۱۹به وسیله ی کربن فعال پسماند انار با استفاده از روش تاگوچی
چکیده فارسی مقاله به وسیله ی کربن فعال برپایه پسماند Reactive Blue 19(RB چکیده- هدف از انجام این پژوهش، تعیین شرایط بهینه حذف رنگ ( انار با استفاده از روش طراحی تاگوچی است. چهار عامل اصلی شامل 9 دقیقه) به عنوان فاکتورهای موثر در راندمان حذف در نظر گرفته شدند که - 500 میلیگرم بر لیتر) و زمان تماس( 1 - اولیه رنگ( 100 غلظت جاذب، غلظت اولیه ،pH برای هر کدام 5 سطح تعیین شد. بر اساس نتایج حاصل از این روش، بیشینه ی بازدهی حذف در 1گرم بر لیتر، 100 میلیگرم بر لیتر و 7 دقیقه به دست آمد. برای تعیین اثر گذاری هر /75 ، رنگ و زمان تماس به ترتیب برابر 11 عامل در حذف رنگ از آنالیز واریانس استفاده شد. بر این اساس، غلظت اولیه رنگ و زمان تماس به ترتیب بیشترین و کمترین اثر را داشتهاند. نتایج بدست آمده نشانگر عملکرد بالا و سریع کربن فعال حاصل از پسماند انار در حذف RB بر بازدهی حذف رنگ 19 از محلول های آبی است
کلیدواژه‌های فارسی مقاله
عنوان انگلیسی Optimization of Reactive Blue 19 adsorption from aqueous solution by pomegranate residual-based activated carbon using Taguchi method
چکیده انگلیسی مقاله Dyes are being extensively used in textile, dyeing and leather industries and usually have a synthetic origin and complex chemical structure that may be mutagenic and carcinogenic. Among various processes of dye removal from wastewater, adsorption is considered to be the most efficient process. Activated carbon is the most widely used adsorbent with great success because of its high adsorption capacity, but its use is limited due to its high-cost, has led to a search for cheaper substitutes. Optimization methods, such as the Taguchi method has been generally adopted to optimize the design parameters, because this systematic approach can significantly minimize the overall testing and the experimental costs. In this study; the optimum condition of Reactive Blue 19(RB19) removal by activated carbon based on pomegranate residual is determined using Taguchi method. For this purpose, 4 main factors such as pH, adsorbent dose, initial dye concentration and contact time were considered in 5 levels. Therefore, an L25 orthogonal array was chosen, and the experimental conditions were obtained. In addition, after design of experiments, an analysis of the signal-to-noise (S/N) ratio was needed to evaluate the experimental results. The analysis of mean (ANOM) statistical approach was adopted herein to construct the optimal conditions. In addition to ANOM, the analysis of variance (ANOVA) statistical method was also used to analyze the influence of each controllable factor on the dye removal efficiency. To prepare the To prepare the activated carbon (AC), pomegranate residual was collected. Collected sample has been dried in an oven for 2 h at 100 0C. It was then ground in a ball mill and the material passed through the No.30 mesh was collected and tested. They were soaked for 24 h in a 1:1 wt. ratio with 50 wt. % phosphoric acid as the carbonized at room temperature. The sample is then decanted and dried in a muffle furnace for 1 h at 500 0C. They were then washed sequentially several times with hot distilled water, until pH of the washing solution became neutral. AC was finally powdered and sieved by the No. 100 mesh. The experiments were done 3 times according to the tests conditions determined by the Taguchi method and the dye removal efficiency was measured. Due to the results of S/N and ANOM, it can be inferred that the optimum mixture proportions to obtain the highest RB19 removal efficiency are as follows. (1) Initial dye concentration of 100 mg/L; (2) pH of 11; (3) adsorbent dose of 1.75 gr/L; and (4) contact time of 7 minutes. The experiment with aforementioned condition was done and result was shown the highest efficiency (98.94%). According to the result of ANOVA, the rank order of the contribution percentage of each factor on RB19 removal efficiency is as follows: (1) initial dye concentration (52.67%), (2) adsorbent dose (33.32%), (3) pH (13.61%), and (4) contact time (2.72%).
کلیدواژه‌های انگلیسی مقاله
نویسندگان مقاله الهام ردایی |
دانشگاه صنعتی امیرکبیر
سازمان اصلی تایید شده: دانشگاه صنعتی امیرکبیر (Amirkabir university of technology)

محمدرضا علوی مقدم | mohammad reza alavi moghaddam
دانشگاه صنعتی امیرکبیر
سازمان اصلی تایید شده: دانشگاه صنعتی امیرکبیر (Amirkabir university of technology)

مختار آرامی |
دانشگاه صنعتی امیرکبیر
سازمان اصلی تایید شده: دانشگاه صنعتی امیرکبیر (Amirkabir university of technology)

نشانی اینترنتی http://mcej.modares.ac.ir/article_11415_408fda543bd83270c8b86754e4f5d760.pdf
فایل مقاله اشکال در دسترسی به فایل - ./files/site1/rds_journals/1242/article-1242-225515.pdf
کد مقاله (doi)
زبان مقاله منتشر شده fa
موضوعات مقاله منتشر شده
نوع مقاله منتشر شده
برگشت به: صفحه اول پایگاه   |   نسخه مرتبط   |   نشریه مرتبط   |   فهرست نشریات