این سایت در حال حاضر پشتیبانی نمی شود و امکان دارد داده های نشریات بروز نباشند
صفحه اصلی
درباره پایگاه
فهرست سامانه ها
الزامات سامانه ها
فهرست سازمانی
تماس با ما
JCR 2016
جستجوی مقالات
یکشنبه 30 آذر 1404
Journal of Mining and Environment
، جلد ۱۱، شماره ۳، صفحات ۸۵۵-۸۶۴
عنوان فارسی
چکیده فارسی مقاله
کلیدواژههای فارسی مقاله
عنوان انگلیسی
Behavior of a Tunnel and its Neighboring Joint with and without Presence of Rock Bolt under Biaxial Loads; Particle Flow Code Approach
چکیده انگلیسی مقاله
In this work, the interaction between the semi-circular space and the neighboring joint with and without the presence of rock bolts was investigated using the particle flow code (PFC) approach. For this purpose, firstly, the calibration of PFC was performed using both the Brazilian experimental test and the uniaxial compression test. Secondly, a numerical model with the dimension of 100 mm * 100 mm was prepared. A semi-circular space with a radius of 25 mm was situated below the model. A joint with a length of 40 mm was situated above the space. The joint opening was 2 mm. The joint angles related to the horizontal direction were 0°, 15°, 30°, 45°, 60°, and 75°. Totally, 6 different configurations of the semi-circular space and neighboring joint were prepared. These models were tested with and without the presence of vertical rock bolts by the biaxial test. The rock bolt length was 50 mm. The value of the lateral force was fixed at 2 MPa. An axial force was applied to the model till the final failure occurred. The results obtained showed that the presence of rock bolts changed the failure pattern of the numerical model. In the absence of rock bolts, two tensile wing cracks initiated from the joint tip and propagated diagonally till coalescence from the model boundary. Also several shear bands were initiated in the left and right sides of the tunnel. In the presence of rock bolts, several shear bands were initiated in the left and right sides of the tunnel. The compressive strength with the presence of rock bolts was more than that without the presence of rock bolts. The failure stress had a minimum value when the joint angle was 45°.
کلیدواژههای انگلیسی مقاله
PFC2D, Tunnel, Joint, rock bolt, tensile crack
نویسندگان مقاله
V. Sarfarazi |
Department of Mining Engineering, Hamedan University of Technology, Hamedan, Iran
نشانی اینترنتی
http://jme.shahroodut.ac.ir/article_1813_f07744ac7007445ebeb7102f8ead2d98.pdf
فایل مقاله
فایلی برای مقاله ذخیره نشده است
کد مقاله (doi)
زبان مقاله منتشر شده
en
موضوعات مقاله منتشر شده
نوع مقاله منتشر شده
برگشت به:
صفحه اول پایگاه
|
نسخه مرتبط
|
نشریه مرتبط
|
فهرست نشریات