این سایت در حال حاضر پشتیبانی نمی شود و امکان دارد داده های نشریات بروز نباشند
صفحه اصلی
درباره پایگاه
فهرست سامانه ها
الزامات سامانه ها
فهرست سازمانی
تماس با ما
JCR 2016
جستجوی مقالات
شنبه 6 دی 1404
Polyolefins Journal
، جلد ۸، شماره ۲، صفحات ۱۲۳-۱۳۳
عنوان فارسی
چکیده فارسی مقاله
کلیدواژههای فارسی مقاله
عنوان انگلیسی
Kinetic study on liquid propylene polymerization using a modified heat flow reaction calorimeter
چکیده انگلیسی مقاله
Bulk phase polymerization of propylene with a 4th generation of Ziegler-Natta catalyst was kinetically investigated by means of heat flow calorimetry. The assumptions and modifications on isothermal calorimetric method were demonstrated. Our calibration method showed that heat exchange with the reactor cover plate is not constant over time. Therefore, the dynamic of cover plate temperature was considered in the calorimetric method. The polymerization rate profiles depending on hydrogen and external electron donor concentration have been investigated. Normalized polymerization profiles (Rp /Rpmax) are plotted and expressed as an exponential function of time. Effects of hydrogen and external electron donor (ED) concentration on Rpmax and polymerization rate were investigated as well. The results showed that by increasing hydrogen concentration, initial polymerization rate (Rpmax) increased. Hydrogen increased productivity by increasing the initial polymerization rate, while it had no negative effect on the rates of decay or its effect was small. The ED concentration was optimized so that the catalyst deactivation rate was at its lowest level. Also, changes in the ratio of activation to inactivation with ED concentration were examined, and a proportional change was observed.
کلیدواژههای انگلیسی مقاله
kinetic study, calorimetry, liquid monomer, Propylene, polymerization
نویسندگان مقاله
Mehrsa Emami |
Department of Process and Modeling, Iran Polymer and Petrochemical Institute, P.O. Box 14185/458, Tehran, Iran
Farzin Hormozi |
Department of Process and Modeling, Iran Polymer and Petrochemical Institute, P.O. Box 14185/458, Tehran, Iran
Hossein Abedini |
Department of Process and Modeling, Iran Polymer and Petrochemical Institute, P.O. Box 14185/458, Tehran, Iran
نشانی اینترنتی
http://poj.ippi.ac.ir/article_1797_7496f24c5d6ad8783684514b862d7cb8.pdf
فایل مقاله
فایلی برای مقاله ذخیره نشده است
کد مقاله (doi)
زبان مقاله منتشر شده
en
موضوعات مقاله منتشر شده
نوع مقاله منتشر شده
برگشت به:
صفحه اول پایگاه
|
نسخه مرتبط
|
نشریه مرتبط
|
فهرست نشریات