این سایت در حال حاضر پشتیبانی نمی شود و امکان دارد داده های نشریات بروز نباشند
مهندسی و مدیریت انرژی، جلد ۱۱، شماره ۳، صفحات ۷۸-۹۱
عنوان فارسی ارائۀ یک فیلتر فعال موازی بهینه‌شده برای بهبود کیفیت توان در یک کارخانۀ فولاد مبتنی بر تئوری P-Q توسعه‌یافته
چکیده فارسی مقاله امروزه مسئلۀ کیفیت توان، پارامتری مهم برای مصرف‌کنندگان انرژی الکتریکی به‌ حساب می‌آید. المان‌های غیرخطی همچون تجهیزات الکترونیک قدرت، کوره‌های قوس الکتریکی، دستگاه‌های فرکانس‌بالا و...) دلیل اصلی وجود مشکلات مربوط به کیفیت توان و ایجاد هارمونیک در شبکه است. در این مقاله، یک روش جدید برای بهبود کیفیت توان در یک کارخانۀ فولاد ارائه شده است. در این روش، برای حذف هارمونیک‌های جریان و ولتاژ که کوره‌های القایی در یک کارخانۀ فولاد ایجاد می‌کنند، از یک فیلتر فعال موازی استفاده شده است. برای بهبود عملکرد فیلتر فعال موازی یک کنترل‌کنندۀ جدید که بر اساس تئوری P-Q  و کنترل‌کنندۀ PID طراحی گردیده، پیشنهاد شده است. همچنین در راستای افزایش عملکرد مناسب فیلتر و بهبود شاخص‌های کیفیت توان، از یک روش بهینه‌سازی مبتنی بر الگوریتم بهینه‌سازی گرگ‌های خاکستری اصلاح‌شده برای تنظیم پارامترهای کنترل‌کننده استفاده گردیده است. با شبیه‌سازی یک کارخانۀ فولاد 10 باسه شامل 6 کورۀ القایی و استفاده از فیلتر فعال موازی ارائه‌شده در محیط نرم‌افزار MATLAB/SIMULINK و آنالیز شاخص‌های هارمونیکی، کارایی ساختار پیشنهادی در افزایش کیفیت توان شبکه قدرت نشان داده شده است.
کلیدواژه‌های فارسی مقاله کیفیت توان، فیلتر فعال موازی، تئوری P-Q توسعه‌یافته، کنترل‌کنندۀ PID، الگوریتم گرگ‌های خاکستری، کارخانۀ فولاد
عنوان انگلیسی Power Quality Improvement in a Steel Plant by an Optimized Shunt Active Power Filter Based on Developed P-Q Theory
چکیده انگلیسی مقاله Introduction: Nowadays, the issue of power quality is an important parameter for electricity consumers. Nonlinear elements (such as electronic power equipment, electric arc furnaces, high frequency devices, etc.) are the main reasons for the problems related to power quality and the creation of harmonics in the network. In this paper, a new method to improve the power quality in a steel plant is presented. A shunt active power filter is used to eliminate current and voltage harmonics of electric arc furnaces in a steel plant in this method. To improve the performance of the shunt active power filter, a new controller based on PID controller and P-Q theory has been proposed. Also, an optimization method based on the modified gray wolf optimization (MGWO) has been used to adjust the control parameters to improve the proper performance of the filter and the quality indices. A 10-bus steel plant, including 6 electric induction furnaces and a shunt active power filter is simulated by MATLAB/Simulink. The analysis of harmonic indices shows the efficiency of the proposed structure to increase the power quality of the power system.   Materials and methods: In this paper, a three-phase-active filter has been used to improve the power quality of a 10-bus steel plant. This plant has six induction furnaces with two different structures which are based on real information. The results of power quality improvement with the proposed control structure have been obtained by simulating this plant. In this filter, by developing the P-Q theory and calculating the active power lost on the rectifier DC bus and adding it to the active power in the P-Q theory, more suitable reference currents are created to produce the required pulses for the active filter rectifier. In the proposed model, the modified gray wolf optimization algorithm is also used to determine the power loss and optimal selection of the parameters of a PID controller. The objective function in the optimization algorithm is to minimize the THD percentage of current and voltage.   Result: The steel plant with the shunt active filter has been simulated using the MATLAB / SIMULINK software environment. The simulations were performed in four steps as shown below and the results of the simulations has been presented in the form of graphs. •The simulation of steel plant without an active filter. • Steel plant simulation in the presence of a classic shunt active filter. • Steel plant simulation in the presence of a developed shunt active filter. •The simulation of steel plant in the presence of a developed and optimized shunt active filter with the MGWO optimization algorithm. The three-phase input voltage and current wave form of the steel plant along with the harmonic components of voltage and current was shown in all four steps. Indices such as THD, TDD and HCR were also used to measure power quality and harmonics for further investigation and comparison. The values ​​of power quality measurement indices and the study of harmonic distortions were also expressed for the four stages of simulation. Also, in order to show the performance of the modified gray wolf optimization algorithm, a developed filter was implemented using the particle swarm optimization algorithm (PSO) and the values ​​have been presented. The results show that the better compensation is provided in the simulation of the steel plant in the presence of an optimized active filter with MGWO algorithm. Also, the efficiency of the proposed method is better than the other methods for all indices (both current and voltage indices). The best values ​​of power quality measurement indices and harmonic distortion for the developed and optimized filter with MGWO have been obtained. Notably, all indices for the proposed method are in the range of IEEE519-2014 standard.   Discussion and Conclusion: In this paper, a new control method for three-phase shunt active filters is presented to improve the power quality and harmonic elimination. The new control structure is based on P-Q theory, PID controller and modified gray wolf optimization algorithm, which has led to the improvement of power quality indices. To show the efficiency of the proposed method, a steel plant with six induction furnaces in the presence of a filter is simulated in MATLAB / SIMULINK software environment. The results of the simulation demonstrate that the proposed filter offers a better compensation in comparison with the classical methods. Also, optimizing the filter can increase the amount of such compensation. Since this simulation is done using the real information of a steel plant, it can greatly help industrial users to improve the power quality of industries.
کلیدواژه‌های انگلیسی مقاله Power Quality, Shunt Active Power Filter, Developed P-Q Theory, PID Controller, Modified Gray Wolf Optimization, Steel Plant
نویسندگان مقاله محمدرضا انصاری | Mohammad Reza Ansari
Shahreza Campus, University of Isfahan
مرکز آموزش عالی شهرضا، دانشگاه اصفهان

سید محمدصادق موسوی قهفرخی | Mohammad Sadegh Mousavi Ghahfarokhi
Shahreza Campus, University of Isfahan
مرکز آموزش عالی شهرضا، دانشگاه اصفهان

شیلا صفایی | Shila Safaee
Semirom Branch, Islamic Azad University
گروه مهندسی برق، دانشگاه آزاد اسلامی واحد سمیرم

نشانی اینترنتی http://energy.kashanu.ac.ir/browse.php?a_code=A-10-2530-1&slc_lang=fa&sid=1
فایل مقاله فایلی برای مقاله ذخیره نشده است
کد مقاله (doi)
زبان مقاله منتشر شده fa
موضوعات مقاله منتشر شده مهندسی برق
نوع مقاله منتشر شده پژوهشی
برگشت به: صفحه اول پایگاه   |   نسخه مرتبط   |   نشریه مرتبط   |   فهرست نشریات