این سایت در حال حاضر پشتیبانی نمی شود و امکان دارد داده های نشریات بروز نباشند
International Journal of Mining and Geo-Engineering، جلد ۵۶، شماره ۲، صفحات ۱۳۹-۱۵۰
عنوان فارسی
چکیده فارسی مقاله
کلیدواژه‌های فارسی مقاله
عنوان انگلیسی Geometry determination of galleries and pillars in Chehel Koureh copper mine, Iran
چکیده انگلیسی مقاله Chehel Koureh mine project is located 110 km NW of Zahedan in the southeast of Iran. Due to the great depth of ore deposits, the underground exploitation method was chosen. In this research, the geomechanical parameters were obtained using in situ tests and empirical formulas. The non-pillar continuous mining method (NPCM) was selected as the most appropriate method considering the shape of the ore body and rock mass strength conditions. As the rock mass is fractured and has semi-continuum characteristics, the stability analysis of the shape dimensions was carried out using FLAC 3D software. In the proposed method, a cylindrical pillar with a height of 3.8 meters was located above the stope. For the safety of the drilling machine room and stope roof, height accuracy was required. Five different pillar diameters (i.e., 3, 3.2, 3.4, 3.6, and 3.8 m) were analyzed by considering the critical height and plastic zone created around the pillar. For these five diameters, only the pillar with a diameter of 3 meters had a supercritical height. It was observed that for the pillar with a diameter of 3.8 m, no plastic zone was created and the safety factor for this pillar was obtained 1.11. Due to the restrictions for the application of the proposed mining method i.e. NPCM in Iran, the Miami method was considered as the alternative mining method applicable to the Chehel Koureh copper deposit. Then, the suitable dimensions for stope and pillar were determined by the same software. In the Miami method, there were three spans and two pillars at each stope before the recovery of pillars could be undertaken. The pillars with three widths of, i.e., 5, 6, and 8 meters were studied for the stability analysis. The results demonstrated that a plastic zone was not created only around the pillar with a width of 8 meters, and the safety factor for this pillar was obtained to be 1.56.
کلیدواژه‌های انگلیسی مقاله Chehel Koureh mine,Non- pillar Continuous Mining Method (NPCM),Miami method,Safety Factor
نویسندگان مقاله Masoud Cheraghi Seifabad |
Department of Mining Engineering, Isfahan University of Technology, Isfahan, Iran

Yousef Mirzadeh Koohshahi |
Department of Mining Engineering, Isfahan University of Technology, Isfahan, Iran

Ali Bameri |
Department of Mining Engineering, Isfahan University of Technology, Isfahan, Iran

نشانی اینترنتی https://ijmge.ut.ac.ir/article_86836_cb4cc5c6c95990ae524dd51fc20e7fef.pdf
فایل مقاله فایلی برای مقاله ذخیره نشده است
کد مقاله (doi)
زبان مقاله منتشر شده en
موضوعات مقاله منتشر شده
نوع مقاله منتشر شده
برگشت به: صفحه اول پایگاه   |   نسخه مرتبط   |   نشریه مرتبط   |   فهرست نشریات