این سایت در حال حاضر پشتیبانی نمی شود و امکان دارد داده های نشریات بروز نباشند
صفحه اصلی
درباره پایگاه
فهرست سامانه ها
الزامات سامانه ها
فهرست سازمانی
تماس با ما
JCR 2016
جستجوی مقالات
دوشنبه 24 آذر 1404
پژوهش های دانش زمین
، جلد ۱۲، شماره ۱، صفحات ۱-۲۰
عنوان فارسی
مدلسازی و ارزیابی ذخیره کانسار سرب و روی فیضآباد با استفاده از روشهای زمینآماری غیرخطی
چکیده فارسی مقاله
در پژوهش حاضر مدلسازی زمینشناسی- اکتشافی کانسار سرب و روی فیضآباد واقع در استان اصفهان انجام شده و از نظر عیار و میزان ذخیره، مورد ارزیابی قرار گرفته است. محدوده کانسار مورد مطالعه براساس توپوگرافی منطقه، میزان و نوع اطلاعات اکتشافی موجود خود به دو منطقه مجزای تپه آقاحساب و کوه خارزن تقسیم شده و مدلسازی کانسار و ارزیابی ذخیره هر منطقه و نیز کل محدوده، بهطور مجزا صورت گرفته است. برای آگاهی از نحوه توزیع دادههای عیارسنجی مجموع سرب و روی و انتخاب درست روش تخمین، ابتدا پردازش آماری اولیه دادهها انجام شد. سپس بهمنظور شناخت کامل و طرح تصویری از وضعیت لیتولوژی کانسار، نگار لیتولوژی تمام گمانههای اکتشافی، مدل سهبعدی لیتولوژی کانسار و مقاطع عرضی لیتولوژی نظیر تعداد زیادی از پروفیلهای شاخص محدوده، ترسیم شد. براساس وضعیت ماده معدنی، میزان و نوع کارهای اکتشافی انجامشده و اطلاعات اکتشافی موجود، از میان روشهای مختلف تخمین ذخیره، روشهای زمینآماری دقیق غیرخطی لاگ کریجینگ معمولی و کریجینگ شاخص، مورد استفاده قرار گرفته و نمودارهای عیار- تناژ ذخیره بهازای عیار حدهای 5/1، 2، 5/2 و 3 درصد ترسیم شد. نتایج پژوهش نشان میدهد که اگرچه هر دو روش زمینآماری مورد استفاده، از دقیقترین روشهای تخمین ذخیره میباشند، اختلاف نتایج تخمین عیار و ذخیره کانسار با روشهای مذکور نسبتاً زیاد است. فقدان اطلاعات اکتشافی کافی و ماهیت روشهای مورد استفاده از مهمترین دلایل این امر هستند ولی در مجموع نتایج روش کریجینگ شاخص قابل اعتمادتر است.
کلیدواژههای فارسی مقاله
تخمین زمینآماری، کانسار سرب و روی فیضآباد، کریجینگ شاخص، لاگ کریجینگ، نرمافزار SGeMS،
عنوان انگلیسی
Modeling and ore reserve evaluation of Feyz-Abad Pb-Zn deposit using non-linear geostatistical methods
چکیده انگلیسی مقاله
Extended abstract Introduction In the present research, geological-exploratory modeling of Feyz-Abad Pb-Zn deposit located in Isfahan province has been carried out as well as evaluation in terms of grade and amount of reserve. The exposed lithology units of the area with possible Paleozoic age from bottom to top, include chlorite schist, carbonate assemblages and green schists. Occurrence of zinc-lead mineralization with carbonate host in a metamorphic sedimentary volcanic sequence is one of the significant mineralization features in this region. The slightly altered limestone and dolomite, perform as host rocks of the deposit. Materials and methods The studied deposit area based on the topography of the region and amount and type of available exploratory information, has been divided into two distinct areas of Aghahesab and Kharzan mountain. So, modeling of the deposit and reserve evaluation of each region and the whole district have been undertaken separately. To know the statistical distribution of total Pb-Zn assay data and the correct choice of estimation method, first the initial statistical processing of the data was performed. Afterwards in order to fully understand and imagine the status of the deposit lithology, the log of all boreholes and drill holes, 3-D lithology model of the deposit and cross sections of lithology corresponding to a large number of the region designated profiles, were mapped. Depending on the mineral state, amount and type of carried out exploratory works and available exploratory information, among the variety of reserve estimation methods, accurate non-linear geostatistical methods containing ordinary log-kriging and indicator kriging have been employed. Then tonnage-grade curves have been plotted for cut off grades of 1.5, 2, 2.5 and 3 percent. Discussion and results The results of the research show that although both applied geostatistical methods are the most accurate of reserve estimation methods, however the difference between the results of estimation (grade and reserve) by means of the two methods is relatively high. The lack of sufficient exploratory information and the nature of the employed methods are the most important reasons for this subject but in general, the results of the indicator kriging method are more reliable. The amount of reserve calculated for various cut off grades in the study zones with the ordinary log kriging method is higher than the indicator kriging. This is due to higher blending of ore and gangue in ordinary log-kriging method than the other. For this reason, in general, the average grade for the variety of cut off grades in the indicator kriging method is higher than the ordinary log-kriging. The difference between the amount of reserve calculated by these two methods for the whole of Feyz-abad lead-zinc deposit for cut off grades of 1.5, 2, 2.5 and 3%, is equal to 26.9, 22, 27 and 17.8%, respectively. Conclusion Nonlinear geostatistical estimation methods have their own complexities, however, understanding the theoretical concepts of these methods properly and selecting their parameters correctly during estimation, will lead to very accurate, useful and desirable results. To increase the accuracy of ore reserve estimation of the studied area, it is suggested that the density of the minerals in various parts of the deposit to be determined by laboratory method with high accuracy. Then, through the index simulation method and determination of material type, an exact density is assigned to each block.
کلیدواژههای انگلیسی مقاله
تخمین زمینآماری, کانسار سرب و روی فیضآباد, کریجینگ شاخص, لاگ کریجینگ, نرمافزار SGeMS
نویسندگان مقاله
رضا احمدی |
گروه مهندسی معدن، دانشکده مهندسی علوم زمین، دانشگاه صنعتی اراک، اراک، ایران
عبدالرضا قره شیخ بیات |
گروه مهندسی معدن، دانشکده مهندسی علوم زمین، دانشگاه صنعتی اراک، اراک، ایران
نشانی اینترنتی
https://esrj.sbu.ac.ir/article_100782_7d571a9a95ca33b01d87a6e29925376a.pdf
فایل مقاله
فایلی برای مقاله ذخیره نشده است
کد مقاله (doi)
زبان مقاله منتشر شده
fa
موضوعات مقاله منتشر شده
نوع مقاله منتشر شده
برگشت به:
صفحه اول پایگاه
|
نسخه مرتبط
|
نشریه مرتبط
|
فهرست نشریات