این سایت در حال حاضر پشتیبانی نمی شود و امکان دارد داده های نشریات بروز نباشند
International Journal of Engineering، جلد ۳۵، شماره ۳، صفحات ۵۶۰-۵۶۶
عنوان فارسی
چکیده فارسی مقاله
کلیدواژه‌های فارسی مقاله
عنوان انگلیسی Experimental Formability Study of Ti6Al4V Sheet Metal using Friction Stir Heat Assisted Single Point Incremental Forming Process
چکیده انگلیسی مقاله Single Point Incremental Forming (SPIF) process is a novel approach of flexible sheet metal forming method in which 3D component can be allowed to form. The process is characterized by die less flexible, lower lead time and higher formability as compare to conventional stamping process. The present work involves set of experiments of 1 mm thick Ti6Al4V sheet using the friction stir SPIF process at room temperature and investigating the effect of wall angle, speed, feed and step size on formability of the sheet. The results revealed that, the maximum formability of frustum cone specimen was obtained at wall angle of 45° and wall angle is the most significant parameter. With an increase in wall angle and feed, the formability of sheet blank decreases while increases in tool rotational speed, the formability found to increase. In addition, it is also observed that, there was no significant influence of step size on formability of sheet.
کلیدواژه‌های انگلیسی مقاله Single Point Incremental Forming,Friction Stir Incremental Forming,Ti6Al4V,Formability
نویسندگان مقاله V. D. Golakiya |
Mechanical Engineering Department, Dr S& S S Ghandhy Government Engineering College Surat, Gujarat Technology University, Gujarat, India

M. K. Chudasama |
Mechanical Engineering Department, Government Engineering College Surat, Gujarat Technology University-395001, Gujarat, India

نشانی اینترنتی https://www.ije.ir/article_141753_21558a943cdd297e6fae86c8df0fd950.pdf
فایل مقاله فایلی برای مقاله ذخیره نشده است
کد مقاله (doi)
زبان مقاله منتشر شده en
موضوعات مقاله منتشر شده
نوع مقاله منتشر شده
برگشت به: صفحه اول پایگاه   |   نسخه مرتبط   |   نشریه مرتبط   |   فهرست نشریات