این سایت در حال حاضر پشتیبانی نمی شود و امکان دارد داده های نشریات بروز نباشند
Iranian Journal of Chemistry and Chemical Engineering، جلد ۴۰، شماره ۵، صفحات ۱۶۱۶-۱۶۲۹
عنوان فارسی
چکیده فارسی مقاله
کلیدواژه‌های فارسی مقاله
عنوان انگلیسی Enhancing the Properties of Styrene-Butadiene Rubber by Adding Borax Particles of Different Sizes
چکیده انگلیسی مقاله In this research study, borax particles with different average sizes (1.25, 0.75, 0.60 μ m) were added to a styrene-butadiene rubber compound for reinforcement. This rubber has low mechanical, thermal, and surface properties, as well as low resistance to organic solvents. A laboratory two-roll mill was used at room temperature to add the borax particles to the synthetic rubber, then the rheometer characteristics such as torque, scorch time, and cure time were limited at a temperature of 150°C. The results showed that the torque and CRI (curing rate index) improved by 160% for torque and 600% for CRI respectively, dependent on reducing the particle size from 1.25 μm to 0.6 μm. The surface properties shown by FE-SEM, AFM images, and FT-IR analysis indicated a good dispersion of borax particles with an absence of the aggregates when a low borax particle size of 0.6 μm was used. Furthermore, the properties of tensile strength, elongation at break, and the hardness of the rubber compound were improved by 220% for tensile strength, 37% for hardness, and the reduction in elongation at break improved by 25% depending on the reduction in particle size. On the other hand, the resistance of the rubber compound to flame improved, besides the improvement of the thermal conductivity with decreasing particle sizes. The resistance of the rubber compound to organic solvents, such as toluene, was also improved, which was represented by the properties of swelling, the percentage of swelling index, and the cross-link density with 1.07% for swelling index and 1.3×10-3 mole/cm3 for cross-link density.
کلیدواژه‌های انگلیسی مقاله Borax particle sizes,Mechanical properties,Styrene-butadiene Rubber,surface properties,Swelling index,Thermal conductivity
نویسندگان مقاله Salih Abbas Habeeb |
Department of Polymers Engineering and Petrochemical Industries, Faculty of Materials Engineering, University of Babylon, Al-Hilla City, IRAQ

Ali S. Hasan |
Department of Polymers Engineering and Petrochemical Industries, Faculty of Materials Engineering, University of Babylon, Al-Hilla City, IRAQ

Ş. Ţălu |
The Directorate of Research, Development and Innovation Management (DMCDI), Technical University of Cluj-Napoca, 15 Constantin Daicoviciu St., Cluj-Napoca, 400020, Cluj County, ROMANIA

Akram J. Jawad |
Department of Polymers Engineering and Petrochemical Industries, Faculty of Materials Engineering, University of Babylon, Al-Hilla City, IRAQ

نشانی اینترنتی https://ijcce.ac.ir/article_40535_a0cfa0e5dac95c9a598a20ddee6d3511.pdf
فایل مقاله فایلی برای مقاله ذخیره نشده است
کد مقاله (doi)
زبان مقاله منتشر شده en
موضوعات مقاله منتشر شده
نوع مقاله منتشر شده
برگشت به: صفحه اول پایگاه   |   نسخه مرتبط   |   نشریه مرتبط   |   فهرست نشریات