این سایت در حال حاضر پشتیبانی نمی شود و امکان دارد داده های نشریات بروز نباشند
Journal of Applied Fluid Mechanics، جلد ۱۶، شماره ۱۲، صفحات ۲۴۵۹-۲۴۷۰
عنوان فارسی
چکیده فارسی مقاله
کلیدواژه‌های فارسی مقاله
عنوان انگلیسی Vertical and Spanwise Wake Flow Structures of a Single Spire over Smooth Wall Surface in a Wind Tunnel
چکیده انگلیسی مقاله The aerodynamic interaction between the wake flow structure behind a single spire with a smooth wall boundary layer at a long streamwise location was observed in a wind tunnel experiment. The application of a single spire is intended to generate a wake flow similar to the one generated behind a skyscraper. A quarter elliptic wedge spire was used and a long streamwise distance of up to 26 times the spire’s height was adopted to ensure the development of the boundary layer and the wake recovery. To grasp how the smooth wall boundary layer interacts with the wake as well as how the wake recovers downstream, vertical and lateral velocity profiles were examined. Despite only one spire being utilized, it was found that the role of the spire as a vortex generator was confirmed the boundary layer height in the with-spire case increased compared to that of the without-spire case. Moreover, the velocity deficit recovery process was observed vertically and streamwise. However, within the boundary layer, the recovery rate in the streamwise direction was lower compared to the above it. This finding indicates that within the boundary, the turbulence generated can sustain the wake caused by the spire, reducing the recovery rate. Based on the current lateral velocity analysis, the final streamwise distance required by the wake to fully recover could not be predicted due to the large velocity deviation of 2.15% at the end of the streamwise distance. 
کلیدواژه‌های انگلیسی مقاله Spire, Wind tunnel experiment, velocity profile, Velocity deficit, Boundary Layer
نویسندگان مقاله M. A. Fitriady |
Faculty of Mechanical and Automotive Engineering Technology, Universiti Malaysia Pahang (UMP), Malaysia

N. A. Rahmat |
Faculty of Mechanical and Automotive Engineering Technology, Universiti Malaysia Pahang (UMP), Malaysia

A. F. Mohammad |
Malaysia-Japan International Institute of Technology, Universiti Teknologi Malaysia (UTM), Malaysia

نشانی اینترنتی https://www.jafmonline.net/article_2314_3ec58af2d88f352254aff4bd3223c028.pdf
فایل مقاله فایلی برای مقاله ذخیره نشده است
کد مقاله (doi)
زبان مقاله منتشر شده en
موضوعات مقاله منتشر شده
نوع مقاله منتشر شده
برگشت به: صفحه اول پایگاه   |   نسخه مرتبط   |   نشریه مرتبط   |   فهرست نشریات