این سایت در حال حاضر پشتیبانی نمی شود و امکان دارد داده های نشریات بروز نباشند
Journal of Applied Fluid Mechanics، جلد ۱۶، شماره ۹، صفحات ۱۷۲۹-۱۷۴۱
عنوان فارسی
چکیده فارسی مقاله
کلیدواژه‌های فارسی مقاله
عنوان انگلیسی Experimental and Numerical Dynamic Investigation of a Swirling Jet: Application to Improve the Efficiency of Air Diffusion in an Occupied Zone
چکیده انگلیسی مقاله When reducing the energy prerequisites of buildings, the correct distribution of fresh air flows injected into the living rooms poses a problem. If the problem of mixing the injected air in the ambient air is not effectively solved, there will be a strong deterioration in air quality and comfort. In this research, a new design of swirling diffuser is investigated experimentally and numerically using large eddy simulations. The influence of fins is studied for the improvement of air diffusion and jet mixing with ambient air. The study was carried out for a fins angle of 30° with the jet's axis and 60° with the blowing orifice's plane with the condition of uniform heat flux of the air. The working fluid used is air. It has been validated that using fins leads to a greater spreading of the jet and good air mixing compared to those obtained from smooth tubes (circular nozzle). To enhance the accuracy of the turbulence models' predictions, three turbulence models are tested: the wall-adapting local eddy-viscosity turbulence model (LES/WALEVM), Smagorinski-Lilly (LES/S-LM) model and the kinetic-energy transport model (LES/K-ETM). It is worth highlighting that the LES/K-ETM model is well established in the prediction of swirling flows, which have been successfully compared with experimental results.
کلیدواژه‌های انگلیسی مقاله Swirl diffusers, Large eddy simulation, Indoor air quality, CFD, Turbulence models
نویسندگان مقاله A. Bennia |
Department of Electromechanics, University Mohamed El Bachir El Ibrahimi of Bordj Bou Arreridj, El-Anasser, 34030 Algeria

A. Reffas |
Department of Electromechanics, University Mohamed El Bachir El Ibrahimi of Bordj Bou Arreridj, El-Anasser, 34030 Algeria

M. A. H. Khan |
Control, Testing, Measurement and Mechanical Simulation Laboratory, University Hassiba Benbouali Hay Salem, National Road 19, Chlef, 02000 Algeria

H. E. Mohamadi |
Department of Software and IT Engineering, École de technologie supérieure, Rue Notre-Dame Ouest, Montréal, QC, H3C 1K3 Canada

M. Lateb |
Department of Mechanical Engineering, Université de Sherbrooke 2500 Blvd. de l’Université, Sherbrooke Qc, J1K 2R1 Canada

H. Fellouah |
Department of Mechanical Engineering, Université de Sherbrooke 2500 Blvd. de l’Université, Sherbrooke Qc, J1K 2R1 Canada

نشانی اینترنتی https://www.jafmonline.net/article_2256_0c3ec107309615b282c57233bc1de33f.pdf
فایل مقاله فایلی برای مقاله ذخیره نشده است
کد مقاله (doi)
زبان مقاله منتشر شده en
موضوعات مقاله منتشر شده
نوع مقاله منتشر شده
برگشت به: صفحه اول پایگاه   |   نسخه مرتبط   |   نشریه مرتبط   |   فهرست نشریات