این سایت در حال حاضر پشتیبانی نمی شود و امکان دارد داده های نشریات بروز نباشند
Journal of Applied Fluid Mechanics، جلد ۱۵، شماره ۴، صفحات ۹۸۵-۹۹۸
عنوان فارسی
چکیده فارسی مقاله
کلیدواژه‌های فارسی مقاله
عنوان انگلیسی Thermo-Hydraulic Analysis of Slightly Inclined Finned Channel under Natural Convection
چکیده انگلیسی مقاله The influence of slight inclination, ‘α’ (i.e., 10°, 15°, and 20°) of the channel comprised of shrouded vertical rectangular non-isothermal fin array has been computationally investigated. Simulations are performed to obtain the convective coefficient of heat transfer for the different dimensionless fin spacing (S*= 0.2, 0.3, 0.5), non-dimensional fin tip to shroud clearances (C*= 0.1, 0.2 and 0.3), Grashof numbers (Gr= 1.08×105, 4.42×105 and 11.5×105), fin lengths (L= 0.25m and 0.5m) and fin heights (H= 0.025m, 0.04m, and 0.055m). Hydrodynamic behavior of the fluid indicates that a significant amount of flow reversal occurs near the entrance of the channel at very low inclination which vanishes with the increase in inclination. Further, at higher length, reverse flow is found to occur only in the clearance zone. An increase in the value of ‘α’ from 10° to 20°, results in enhancement of convective coefficient up to a maximum of 161%. An increase in the value of fin spacing from 0.2 to 0.5 results in the enhancement of the convective heat transfer coefficient. At α= 15° and 20°, the heat transfer is enhanced by 84.1% and 101.6%, respectively, while at α=10°, the same is reduced by 33.3%. At lower fin spacing (S*<0.3) increase in C* tends to reduce the efficiency. Further, the efficiency of the finite conductive fin is found to reduce by almost 8% with an increase in Grashof number.
کلیدواژه‌های انگلیسی مقاله Grashof number, Inclination, Clearance, Convective coefficient, Fin efficiency
نویسندگان مقاله K. Roy |
Department of Mechanical Engineering, Regional Institute of Science and Technology, Baridua, Ri-Bhoi, Meghalaya, 793101, India

B. Das |
Department of Mechanical Engineering, National Institute of Technology, Silchar, Assam, 788010, India

K. K. Pathak |
Department of Mechanical Engineering, Girijananda Chowdhury Institute of Management and Technology, Guwahati, Assam, 781017, India

A. Giri |
Department of Mechanical Engineering, North Eastern Regional Institute of Science and Technology, Nirjuli-791109, India

نشانی اینترنتی https://www.jafmonline.net/article_2044_6c8acbace0aa22090a6249d85386af52.pdf
فایل مقاله فایلی برای مقاله ذخیره نشده است
کد مقاله (doi)
زبان مقاله منتشر شده en
موضوعات مقاله منتشر شده
نوع مقاله منتشر شده
برگشت به: صفحه اول پایگاه   |   نسخه مرتبط   |   نشریه مرتبط   |   فهرست نشریات