این سایت در حال حاضر پشتیبانی نمی شود و امکان دارد داده های نشریات بروز نباشند
Journal of Applied Fluid Mechanics، جلد ۱۳، شماره ۶، صفحات ۱۸۴۷-۱۸۵۸
عنوان فارسی
چکیده فارسی مقاله
کلیدواژه‌های فارسی مقاله
عنوان انگلیسی Numerical Analysis of Flow Geometry in I-Shaped Viscous Micropumps using LB-IBM
چکیده انگلیسی مقاله In viscous micropumps one of the main reasons for a flow rate reduction is vortices which are located at the top of the rotating rotor. In this paper, we have tried to add proper additional walls in the micropump channel, to eliminate or decrease the size of these vortices. Among the all investigated new models, only one, the I-Shaped micropump with an extra step above the rotor, could reduce the size of the vortices and also increase the outlet flow rate. In this paper, the numerical simulations were conducted by using the Lattice Boltzmann Method and by exploiting the Immersed Boundary method and the Blocking technique in order to overcome the LBM drawbacks. The results show that at the channel height H^*=3.7, this new model can produce a flow rate of 150% more than the normal I-Shaped micropumps. Also, one can tune the maximum produced pressure by adjusting the height of this step and micropump with higher channel height can be much more efficient and usable. In addition, by using this new structure for micropump, the designers can also use bigger channel heights which were not efficient in the original design.
کلیدواژه‌های انگلیسی مقاله Lattice Boltzmann method, Viscous micropump, Immersed boundary method
نویسندگان مقاله A. Alimoradi |
Department of Mechanical Engineering, University of Birjand, Birjand, Iran

S. Ali Mirbozorgi |
Department of Mechanical Engineering, University of Birjand, Birjand, Iran

نشانی اینترنتی https://www.jafmonline.net/article_1051_b8888d5d247711a3441f12911795dceb.pdf
فایل مقاله فایلی برای مقاله ذخیره نشده است
کد مقاله (doi)
زبان مقاله منتشر شده en
موضوعات مقاله منتشر شده
نوع مقاله منتشر شده
برگشت به: صفحه اول پایگاه   |   نسخه مرتبط   |   نشریه مرتبط   |   فهرست نشریات