این سایت در حال حاضر پشتیبانی نمی شود و امکان دارد داده های نشریات بروز نباشند
Journal of Applied Fluid Mechanics، جلد ۱۲، شماره ۳، صفحات ۸۰۳-۸۱۷
عنوان فارسی
چکیده فارسی مقاله
کلیدواژه‌های فارسی مقاله
عنوان انگلیسی Experimental Analysis of Heat Transfer and Multi Objective Optimization of Swirling Jet Impingement on a Flat Surface
چکیده انگلیسی مقاله The influence of swirling flow on distribution of wall heat transfer on a flat plate with helicoid swirl inserts is experimentally studied. The focus of the study is on the swirling effect imposed by helicoid surfaces. Six helicoid swirl inserts of single vane, double vanes and triple vanes with swirl number (Sw) of 0.75 and 1.1 are used in this study. The heat transfer measurements are made for the Reynolds number range of 12700 - 32700 and for the nozzle exit to impinging plate distance (H/D) of 1, 2, 3 and 4 using thermo chromic liquid crystal technique. The swirling impinging jet is also compared with circular impinging jet on the heat transfer performance. The obtained experimental results provide the information on the behavior of single, double and triple helicoid swirl inserts on the heat transfer performance. The experimental values are analyzed with multi objective optimization technique of principle component analysis by computing multi response performance index (MRPI). Their performance is presented in terms of heat transfer rate through evaluation of Nusselt number on the impinging surface and heat transfer uniformity and decay of Nusselt number. The principle component analysis reveals that the double helicoid with higher H/D ratio improves performance of the swirling jet with relatively higher computed MRPI. It is found from the analysis of variance (ANOVA) that the H/D ratio contributes significant effect on the output followed by number of helicoid vanes and swirl number.
کلیدواژه‌های انگلیسی مقاله Heat transfer, Swirling impinging jet, Thermochromic liquid crystal, Optimization
نویسندگان مقاله S. Mohamed Illyas |
Department of Mechanical Engineering, Jawaharlal Nehru Technological University, Kakinada-533003, India

B. R. Ramesh Bapu |
Department of Mechanical Engineering, Chennai Institute of Technology, Chennai-600069, India

V. Venkata Subba Rao |
Department of Mechanical Engineering, Jawaharlal Nehru Technological University, Kakinada-533003, India

نشانی اینترنتی https://www.jafmonline.net/article_795_8dd5db5c9058fbaa3cffe63a37b93fad.pdf
فایل مقاله فایلی برای مقاله ذخیره نشده است
کد مقاله (doi)
زبان مقاله منتشر شده en
موضوعات مقاله منتشر شده
نوع مقاله منتشر شده
برگشت به: صفحه اول پایگاه   |   نسخه مرتبط   |   نشریه مرتبط   |   فهرست نشریات