این سایت در حال حاضر پشتیبانی نمی شود و امکان دارد داده های نشریات بروز نباشند
Journal of Applied Fluid Mechanics، جلد ۱۲، شماره ۱، صفحات ۲۹۳-۳۰۲
عنوان فارسی
چکیده فارسی مقاله
کلیدواژه‌های فارسی مقاله
عنوان انگلیسی Bluff Body Drag Control using Synthetic Jet
چکیده انگلیسی مقاله The paper presents the results of an experimental investigation wherein the bullet form drag force as a function of oscillating actuator frequency, various voltage and for different orifice/slot configuration are studied. In order to perform the experiment, an axisymmetric bullet shape model with ellipsoidal nose was used in wind tunnel. The synthetic jet actuator was used to flow control at sharp cut end. The experiment was conducted in a wind tunnel with a working diameter of 1000 mm and a maximum velocity of 45 m/s. The measurements were carried out for the Reynolds number from 88000 to 352000 and for relatively large Strouhal numbers up to St = 4.5 based on model external diameter and free stream velocity. While synthetic jet was switched on, drag coefficient has been reduced by -6% and increased by +22% in relation to the case with the synthetic jet was switched off. The synthetic jet has more impact for relatively low free stream velocity and for single axisymmetric orifice.
کلیدواژه‌های انگلیسی مقاله Synthetic jet, Zero, net, flux, mass, Bluff body, Bullet shaped body, Drag
نویسندگان مقاله P. Gil |
Rzeszow University of Technology, The Faculty of Mechanical Engineering and Aeronautics, Rzeszow, 35-959, al. Powstańców Warszawy 8, Poland

نشانی اینترنتی https://www.jafmonline.net/article_742_89969b2aeb23f066a8c15793aaf0cb3c.pdf
فایل مقاله فایلی برای مقاله ذخیره نشده است
کد مقاله (doi)
زبان مقاله منتشر شده en
موضوعات مقاله منتشر شده
نوع مقاله منتشر شده
برگشت به: صفحه اول پایگاه   |   نسخه مرتبط   |   نشریه مرتبط   |   فهرست نشریات