این سایت در حال حاضر پشتیبانی نمی شود و امکان دارد داده های نشریات بروز نباشند
Journal of Applied Fluid Mechanics، جلد ۱، شماره ۲، صفحات ۶۵-۸۶
عنوان فارسی
چکیده فارسی مقاله
کلیدواژه‌های فارسی مقاله
عنوان انگلیسی Numerical Analysis of the Combustion Process in a Compressed Natural Gas Direct Injection Engine
چکیده انگلیسی مقاله The design, development and optimization of an internal combustion engine require the application of a modern sophisticated analysis tool. In addition to experimental work, numerical calculations are now necessary to provide an insight into the complex in-cylinder process. The combustion process and its emission characteristics in a compressed natural gas direct injection engine were analyzed and investigated. The numerical studies were performed on a single cylinder of a 1.6-liter engine running at wide open throttle. The grid generation was established through an embedded algorithm for moving mesh and boundary in order to provide a more accurate transient condition. The combustion process was modelled with the eddy break-up model of Magnussen for unpremixed or diffusion reaction with three global reaction scheme. The computational fluid dynamics (CFD) simulations at two baseline conditions are carried out to examine the fluid flow, air-fuel mixing formation, combustion process, carbon monoxide emission distribution as well as NO emission formation occurred inside engine cylinder. The CFD results were compared with the experimental data and showed a very good agreement for two baseline conditions. A set of parametric studies were carried out by varying the timings of start of injection (SOI) and start of ignition (SI). The examined engine performance is in-cylinder pressure, while the considered emissions to be minimised are CO and NO levels. In order to study the effect of injection timing, the SOI timing was varied from 120º -140º with fixed ignition timing at 19º bTDC. On the other hand, SI timing was positioned from 15º-23º bTDC with fixed SOI timing for studying its influences. The CFD results indicated that slightly retarded SOI and SI timing can be chosen to reduce CO and NO levels while increasing engine performance.
کلیدواژه‌های انگلیسی مقاله CFD, combustion, moving mesh, moving boundary, diffusion reaction, injection, ignition
نویسندگان مقاله S. Abdullah |
Department of Mechanical and Materials Engineering, National University of Malaysia, Bangi, Selangor D.E., 43600 UKM Bangi, Malaysia

W. Hardyono Kurniawan |
Department of Mechanical and Materials Engineering, National University of Malaysia, Bangi, Selangor D.E., 43600 UKM Bangi, Malaysia

A. Shamsudeen |
Department of Mechanical and Materials Engineering, National University of Malaysia, Bangi, Selangor D.E., 43600 UKM Bangi, Malaysia

نشانی اینترنتی https://www.jafmonline.net/article_407_9dad8ea9da33b6c680c0327a4b3258f4.pdf
فایل مقاله فایلی برای مقاله ذخیره نشده است
کد مقاله (doi)
زبان مقاله منتشر شده en
موضوعات مقاله منتشر شده
نوع مقاله منتشر شده
برگشت به: صفحه اول پایگاه   |   نسخه مرتبط   |   نشریه مرتبط   |   فهرست نشریات