این سایت در حال حاضر پشتیبانی نمی شود و امکان دارد داده های نشریات بروز نباشند
Journal of Mining and Environment، جلد ۱۵، شماره ۱، صفحات ۵۵-۷۱
عنوان فارسی
چکیده فارسی مقاله
کلیدواژه‌های فارسی مقاله
عنوان انگلیسی Statistical Analysis and Optimization of Drilling Process using Response Surface Methodology and Experimental Data
چکیده انگلیسی مقاله It is well-established that the response surface methodology (RSM) is commonly employed to establish the differences between the predicted values and those observed experimentally. This study mainly goals on the impact of four drilling factors including weight on the bit (WOB), the rotating rapidity of the bit, RPM, cutting angle , and rock resistance on the penetration rate of the drilling tool. In this examination, three kinds of limestone rocks were considered. The planned assessments were carried out at three stages of the considered four input variables. The statistical analysis was realized using both RSM approach and analysis of variance (ANOVA). This analysis allowed us to develop the appropriate penetration model with a higher determination coefficient of 96.19%, which demonstrates the high correlation between the predicted and experimental data, and consequently, it can be concluded that the obtained model is highly suitable for the prediction of the penetration rate. Also from variance analysis, the results obtained show that rotational speed, RPM, and weight on the bit (WOB) parameters, as well as the nature of the rock, which is determined by the rock compressive resistance, having a significant effect on the penetration rate; however, the rake angle has little effect. Finally, the optimal parameters were determined to find the best possible penetration rate of the drilling tool.
کلیدواژه‌های انگلیسی مقاله Optimization, Experimental data, Drilling Parameters, Optimal parameters, RMS and ANOVA
نویسندگان مقاله Rym Khettabi |
Mechanical Engineering Department, University of 20 Août 1955 Skikda, El Hadaiek Road, Skikda, Algeria

Issam Touil |
Mechanical Engineering Department, University of 20 Août 1955 Skikda, El Hadaiek Road, Skikda, Algeria

Mohamed Kezzar |
Mechanical Engineering Department, University of 20 Août 1955 Skikda, El Hadaiek Road, Skikda, Algeria

Mohamed R. Eid |
Department of Mathematics, Faculty of Science, New Valley University, El-Kharga, Al-Wadi Al-Gadid, Egypt

Fatima.Z Derdour |
Mechanical Engineering Department, University of 20 Août 1955 Skikda, El Hadaiek Road, Skikda, Algeria

Kamel Khounfais |
Physical Engineering Department, University of 20 Août 1955 Skikda, El Hadaiek Road, Skikda, Algeria

Lakhdar Khochmane |
Mechanical Engineering Department, University of 20 Août 1955 Skikda, El Hadaiek Road, Skikda, Algeria

نشانی اینترنتی https://jme.shahroodut.ac.ir/article_2949_40a32fc1c74e12861427e368047c46e5.pdf
فایل مقاله فایلی برای مقاله ذخیره نشده است
کد مقاله (doi)
زبان مقاله منتشر شده en
موضوعات مقاله منتشر شده
نوع مقاله منتشر شده
برگشت به: صفحه اول پایگاه   |   نسخه مرتبط   |   نشریه مرتبط   |   فهرست نشریات