این سایت در حال حاضر پشتیبانی نمی شود و امکان دارد داده های نشریات بروز نباشند
صفحه اصلی
درباره پایگاه
فهرست سامانه ها
الزامات سامانه ها
فهرست سازمانی
تماس با ما
JCR 2016
جستجوی مقالات
یکشنبه 23 آذر 1404
Journal of Applied Fluid Mechanics
، جلد ۱۷، شماره ۶، صفحات ۱۳۰۶-۱۳۲۱
عنوان فارسی
چکیده فارسی مقاله
کلیدواژههای فارسی مقاله
عنوان انگلیسی
Effects of the Reynolds Number on the Efficiency and Stall Mechanisms in a Three-stage Axial Compressor
چکیده انگلیسی مقاله
The Reynolds number (
R
e) is an important parameter that can affect compressor performance. This study experimentally and numerically investigated the effect of
R
e variations on the efficiency and stall mechanisms for a three-stage axial flow compressor. In the experiment, the total pressure ratio, polytropic efficiency, and stalling mass flow rate were measured in a
R
e range varying from 1,100,000 to 55,000 to elucidate the
R
e effects. Unsteady three-dimensional numerical simulations were implemented to understand the stall mechanisms. The results indicate that the compressor efficiency and stall–pressure ratio begin to decrease remarkably as
R
e is reduced below a critical value, which is 220,000 in the case of the compressor studied. At a low
R
e, losses caused by the secondary flow near the hub and shroud increase remarkably, and the extended boundary layer separations at the blade suction surface further decrease the efficiency. The variation in
R
e changes the stall-initiated location. At higher Reynolds numbers, the interaction between the corner separation at the hub of stator 1 and the leakage flow through the blade tip gap induces a large vortex, which seriously blocks the blade passage. The blocking effect spreads to the aft stage and extends to higher spans, which results in the stall of the whole compressor. However, the blocking effect at the hub disappears at
R
e =55,000, and the interaction of the blade boundary layer separation near the shroud of rotor 1 and the tip leakage vortex causes a large blockage and then induces stall. The
R
e variation changes the radial flow transportation because of the varying effect on the aerodynamic performance of each blade element at different spans. This significantly influences the extent of the vortex near the end wall and ultimately changes the stall mechanisms.
کلیدواژههای انگلیسی مقاله
Compressor performance,Numerical and experimental research,Reynolds number variation,Critical Reynolds Number,Stall separation,Blocking flow,Secondary flow
نویسندگان مقاله
E. Zhou |
High Speed Aerodynamics Institute, China Aerodynamics Research and Development Center, Mianyang 621000, China
P. Lei |
High Speed Aerodynamics Institute, China Aerodynamics Research and Development Center, Mianyang 621000, China
C. Fan |
High Speed Aerodynamics Institute, China Aerodynamics Research and Development Center, Mianyang 621000, China
W. Zhang |
High Speed Aerodynamics Institute, China Aerodynamics Research and Development Center, Mianyang 621000, China
K. Liu |
High Speed Aerodynamics Institute, China Aerodynamics Research and Development Center, Mianyang 621000, China
S. Cheng |
High Speed Aerodynamics Institute, China Aerodynamics Research and Development Center, Mianyang 621000, China
نشانی اینترنتی
https://www.jafmonline.net/article_2424_49cedab486dec8cea5e9c404b449b3ff.pdf
فایل مقاله
فایلی برای مقاله ذخیره نشده است
کد مقاله (doi)
زبان مقاله منتشر شده
en
موضوعات مقاله منتشر شده
نوع مقاله منتشر شده
برگشت به:
صفحه اول پایگاه
|
نسخه مرتبط
|
نشریه مرتبط
|
فهرست نشریات