این سایت در حال حاضر پشتیبانی نمی شود و امکان دارد داده های نشریات بروز نباشند
International Journal of Mining and Geo-Engineering، جلد ۵۸، شماره ۴، صفحات ۳۵۹-۳۷۰
عنوان فارسی
چکیده فارسی مقاله
کلیدواژه‌های فارسی مقاله
عنوان انگلیسی Refinement of the flotation reagent plan based on coal feed ash content
چکیده انگلیسی مقاله The effect of frother dosage (67, 200, and 400 g/t), collector dosage (200, 600, and 1000 g/t), and frother type (Mixed aliphatic alcohol (MAA), Methyl Isobutyl Carbinol (MIBC), and pine oil) on the flotation performance of three coal samples with various ash contents of 45.1% (high ash content coal, HAC), 36.8% (moderate ash content coal, MAC), and 30.7% (low ash content coal, LAC) was studied. The optimal flotation conditions for each coal sample were quite different. For HAC, a clean coal with an ash content of 12.8% and a yield of 38% was produced under optimal conditions using MIBC as the frother dosage of 361 g/t, and a collector dosage of 200 g/t. In the case of MAC, a clean coal with an ash content of 10.2% and a yield of 46% was produced under optimal flotation conditions using MAA as the frother dosage of 148 g/t, and a collector dosage of 200 g/t. For LAC, a clean coal with an ash content of 9.87% and a yield of 57.4% was produced under optimal flotation conditions using pine oil as the frother dosage of 174 g/t, and a collector dosage of 1000 g/t. For LAC feed coal, in comparison with HAC feed coal, a lower frother at dosage, higher collector dosage, and pine oil frother instead of MIBC must be used. The optimal conditions for HAC flotation were validated in a coal washing plant. After conducting the necessary modifications to the flotation reagent scheme, yield, combustive material recovery (CMR) and separation efficiency (SE) of the plant increased by 5.9%, 11%, and 7.5%, respectively which results in more clean coal production of about 14160 t/y.
کلیدواژه‌های انگلیسی مقاله Flotation,Feed coal ash content,Flotation reagent scheme,Process optimization,Laboratory and plant validations
نویسندگان مقاله Fatemeh Bakhshiyan |
Faculty of Engineering, University of Birjand, Birjand, South Khorasan, Iran.

Ali Behnamfard |
Faculty of Engineering, University of Birjand, Birjand, South Khorasan, Iran.

Mehdi Alidokht |
Senior process engineer, Tabas Parvadeh Coal Company (TPCCO).

نشانی اینترنتی https://ijmge.ut.ac.ir/article_98745_a5e6843fe81202485c7399fa7fb892ff.pdf
فایل مقاله فایلی برای مقاله ذخیره نشده است
کد مقاله (doi)
زبان مقاله منتشر شده en
موضوعات مقاله منتشر شده
نوع مقاله منتشر شده
برگشت به: صفحه اول پایگاه   |   نسخه مرتبط   |   نشریه مرتبط   |   فهرست نشریات