این سایت در حال حاضر پشتیبانی نمی شود و امکان دارد داده های نشریات بروز نباشند
Journal of Applied Fluid Mechanics، جلد ۱۸، شماره ۴، صفحات ۹۱۹-۹۳۲
عنوان فارسی
چکیده فارسی مقاله
کلیدواژه‌های فارسی مقاله
عنوان انگلیسی Unsteady Flow Mechanisms of the Stability Improvement for an Optimized Compressor
چکیده انگلیسی مقاله Radial compressor is a crucial component of turbocharging systems in aviation engines. Enhancing flow stability of radial compressor contributes to performances improvement of engines. Ported shroud (P-S) casing-treatment can effectively broaden the compressors flow stability range. However, the unsteady mechanisms of the P-S are still unclear. In this study, a collaborative optimization of the P-S and the impeller-diffuser is firstly carried out. The results show that the optimized compressor exhibits higher efficiency and larger flow stability range than the original and the solid-casing compressors. Then, the unsteady mechanisms of the flow stability enhancement for the optimized compressor are analyzed by the dynamic-mode-decomposition (DMD) method. It is found that the decrease of the energy proportion of the inherent mode and the increase of the low-frequency multi-scale modes are correlated to the flow instability of the compressor. The increased recirculating flow rate of the optimized compressor has removed more tip leakage flow (TLF) and double leakage flow (DLF) in the impeller inducer shroud, and then reduces the interplay among the TLF, the DLF and the leading-edge (LE) shock wave. Therefore, the generation of low-frequency multi-scale modes is suppressed, while the inherent modes are intensified. Consequently, the flow stability of the compressor is enhanced. This study may offer a new approach to enhance compressor stability by adjusting the energy proportions of inherent modes and low-frequency multi-scale modes. 
کلیدواژه‌های انگلیسی مقاله Radial compressor,Dynamic-mode-decomposition,Ported shroud,Mode energy transfer,Unsteady mechanisms of stability enhancement
نویسندگان مقاله T. Zhou |
School of Mechanical Engineering, Tianjin University, 300350 Tianjin, China

Z. X. Liu |
School of Mechanical Engineering, Tianjin University, 300350 Tianjin, China

X. J. Li |
School of Mechanical Engineering, Tianjin University, 300350 Tianjin, China

M. Zhao |
School of Mechanical Engineering, Tianjin University, 300350 Tianjin, China

Y. J. Zhao |
School of Mechanical Engineering, Tianjin University of Commerce, 300134 Tianjin, China

L. C. Xu |
School of Mechanical Engineering, Tianjin University, 300350 Tianjin, China

نشانی اینترنتی https://www.jafmonline.net/article_2606_f39c1357ddcdc48aa1eb3644c502b841.pdf
فایل مقاله فایلی برای مقاله ذخیره نشده است
کد مقاله (doi)
زبان مقاله منتشر شده en
موضوعات مقاله منتشر شده
نوع مقاله منتشر شده
برگشت به: صفحه اول پایگاه   |   نسخه مرتبط   |   نشریه مرتبط   |   فهرست نشریات