این سایت در حال حاضر پشتیبانی نمی شود و امکان دارد داده های نشریات بروز نباشند
صفحه اصلی
درباره پایگاه
فهرست سامانه ها
الزامات سامانه ها
فهرست سازمانی
تماس با ما
JCR 2016
جستجوی مقالات
یکشنبه 23 آذر 1404
Journal of Applied Fluid Mechanics
، جلد ۱۸، شماره ۶، صفحات ۱۴۳۰-۱۴۴۵
عنوان فارسی
چکیده فارسی مقاله
کلیدواژههای فارسی مقاله
عنوان انگلیسی
Effect of Disk Friction Loss Reduction on Flow Phenomena in Low-specific Speed Centrifugal Pump: An Experimental and Numerical Approach
چکیده انگلیسی مقاله
Disk friction loss (
L
DF
) plays an important factor in the performance of the low-specific speed (
N
S
) centrifugal pump. Reducing the rear axial clearance (
C
s,a,r
) is profound method to lower the
L
DF
and improve the efficiency of pump (
η
). In this research article, a low
N
S
= 19 rpm centrifugal pump was evaluated using computational fluid dynamics (CFD) and experimental analysis at different 1000, 900 and 800 rpms over a range of flow rates (
Q
). Two models: Model A with original
C
s,a,r
of 23 mm and Model B with reduced
C
s,a,r
of 1 mm were analyzed. To grasp the knowledge about internal flow physics, the pressure contours, velocity contours, velocity vectors and streamlines have been thoroughly studied. CFD results were found in good agreement with the experiments performed on the test setup. The experimental improvements in
η
at their respective best efficiency points (BEP) were determined to be 3.94%, 3.91%, and 2.81% for 1000, 900, and 800 rpms respectively. While an average 3.43%, 1.79% and 0.76% improvement in head (
H
) was obtained for 1000, 900, and 800 rpms respectively. Considering the lower disk friction coefficient (
C
m
) and power loss (
P
L
) due to
L
DF
, the Model B works optimum at higher rpm.
کلیدواژههای انگلیسی مقاله
Low-specific speed pump,Disk friction loss,Clearance flow,CFD,Cavity filling ring
نویسندگان مقاله
D. Satish |
Department of Mechanical Engineering, Sardar Vallabhbhai National Institute of Technology, Surat 395007, Gujarat, India
A. Doshi |
Department of Mechanical Engineering, Sardar Vallabhbhai National Institute of Technology, Surat 395007, Gujarat, India
M. Bade |
Department of Mechanical Engineering, Sardar Vallabhbhai National Institute of Technology, Surat 395007, Gujarat, India
نشانی اینترنتی
https://www.jafmonline.net/article_2642_9bc26d9f5ccf240465622931fd18fd1f.pdf
فایل مقاله
فایلی برای مقاله ذخیره نشده است
کد مقاله (doi)
زبان مقاله منتشر شده
en
موضوعات مقاله منتشر شده
نوع مقاله منتشر شده
برگشت به:
صفحه اول پایگاه
|
نسخه مرتبط
|
نشریه مرتبط
|
فهرست نشریات