این سایت در حال حاضر پشتیبانی نمی شود و امکان دارد داده های نشریات بروز نباشند
Journal of Applied Fluid Mechanics، جلد ۱۸، شماره ۸، صفحات ۲۰۸۵-۲۰۹۴
عنوان فارسی
چکیده فارسی مقاله
کلیدواژه‌های فارسی مقاله
عنوان انگلیسی Numerical Simulation of Coupled CFD-flight Mechanics and Taguchi’s Approach for Reliability and Safety Assessments in the Hot Stage Separation of a Launch Vehicle
چکیده انگلیسی مقاله This research presents a numerical simulation of a two-stage launch vehicle's hot stage separation process. Important parameters, such as the separation altitude, flight Mach number, and the angle of attack during separation, were investigated. The effects of these factors and the motor thrust parameter on the distance between the two stages post-separation were evaluated using the Taguchi method. Numerical analysis was performed using ANSYS Fluent, solving the three-dimensional flow field under the six degrees of freedom (6DOF) assumption. The SST k-ω turbulence model was employed for turbulence modeling, with a tetrahedral unstructured mesh used for the computational domain. The simulation results showed that increasing the separation altitude from 10 km to 20 km increased the distance between the two stages by 5.75%, primarily due to reduced air density and drag forces. Raising the flight Mach number from 2 to 3.2 increased the separation distance of two stages by 2.2%. Additionally, a higher angle of attack increased the deviation of the stages from their original trajectory, necessitating stage control after separation. Among the parameters studied, the motor thrust has the most significant effect on increasing the distance between the stages and preventing collisions. In contrast, the angle of attack has the most minor influence.
کلیدواژه‌های انگلیسی مقاله Two-stage launch vehicle,Taguchi’s approach,Altitude,Flight Mach number,Angle of attack
نویسندگان مقاله D. Nasiri |
Faculty of Mechanical Engineering, Malek-ashtar University of Technology, Isfahan, Iran

M. Adami |
Faculty of Mechanical Engineering, Malek-ashtar University of Technology, Isfahan, Iran

H. Taei |
Faculty of Engineering, Department of Aerospace Engineering, University of Isfahan, Isfahan, Iran

H. Parhizkar |
Department of Mechanical Engineering, Malek-ashtar University of Technology, Tehran, Iran

نشانی اینترنتی https://www.jafmonline.net/article_2693_1ee8377aa7618732da2574c1a8f101ca.pdf
فایل مقاله فایلی برای مقاله ذخیره نشده است
کد مقاله (doi)
زبان مقاله منتشر شده en
موضوعات مقاله منتشر شده
نوع مقاله منتشر شده
برگشت به: صفحه اول پایگاه   |   نسخه مرتبط   |   نشریه مرتبط   |   فهرست نشریات