این سایت در حال حاضر پشتیبانی نمی شود و امکان دارد داده های نشریات بروز نباشند
Journal of Applied Fluid Mechanics، جلد ۱۸، شماره ۸، صفحات ۲۰۹۵-۲۱۰۷
عنوان فارسی
چکیده فارسی مقاله
کلیدواژه‌های فارسی مقاله
عنوان انگلیسی Optimization of Structural Parameters and Cavitation Suppression in Control Valves Based on P-WOA
چکیده انگلیسی مقاله A control valve is a critical component in water supply systems, controlling pressure, flow, and direction. However, cavitation, caused by low pressure in the valve cavity, disrupts flow and leads to cavitation damage, vibration, and noise, affecting valve reliability and system stability. In this study an optimization method for controlling valve structural parameters is proposed to reduce cavitation-induced flow resistance and enhance flow capacity. Using the orifice throttling principle, the continuity equation, and Bernoulli's equation, the relationship between cavitation-induced resistance and flow rate is analyzed. Numerical calculations reveal that cavitation is most severe at a 40% valve opening, which is further studied. Boosting method integrates reinforcement learning PPO with the whale optimization algorithm (WOA) to form the P-WOA model. SOLIDWORKS and CFD software are used for parametric modeling, and a control valve structural parameter database is created using Latin hypercube sampling. The database is input into the P-WOA model for training to find optimal valve parameters. These solutions are then globally optimized by the WOA. The simulation and experimental results show that the P-WOA-optimized valve parameters significantly reduce cavitation (the gas volume fraction is reduced by 99.8% compared with the original and 59.6% compared with the PPO optimization) and improve the flow capacity. This proves the effectiveness of the P-WOA model and provides a new structural optimization solution for reducing cavitation in engineering.
کلیدواژه‌های انگلیسی مقاله Control valve,Throttling orifice,Cavitation flow,Reinforcement learning,Whale optimization algorithm
نویسندگان مقاله J. Hou |
School of Petrochemical Engineering, Lanzhou University of Technology, Lanzhou 730050, PR China

J. Hou |
School of Petrochemical Engineering, Lanzhou University of Technology, Lanzhou 730050, PR China

J. Hou |
School of Petrochemical Engineering, Lanzhou University of Technology, Lanzhou 730050, PR China

L. Yang |
School of Petrochemical Engineering, Lanzhou University of Technology, Lanzhou 730050, PR China

Y. Tian |
School of Petrochemical Engineering, Lanzhou University of Technology, Lanzhou 730050, PR China

نشانی اینترنتی https://www.jafmonline.net/article_2694_75e65225c5425aed26a8e67883367193.pdf
فایل مقاله فایلی برای مقاله ذخیره نشده است
کد مقاله (doi)
زبان مقاله منتشر شده en
موضوعات مقاله منتشر شده
نوع مقاله منتشر شده
برگشت به: صفحه اول پایگاه   |   نسخه مرتبط   |   نشریه مرتبط   |   فهرست نشریات