این سایت در حال حاضر پشتیبانی نمی شود و امکان دارد داده های نشریات بروز نباشند
صفحه اصلی
درباره پایگاه
فهرست سامانه ها
الزامات سامانه ها
فهرست سازمانی
تماس با ما
JCR 2016
جستجوی مقالات
چهارشنبه 26 آذر 1404
مهندسی عمران مدرس
، جلد ۲۵، شماره ۴، صفحات ۰-۰
عنوان فارسی
افت انرژی دریچههای کشویی تحت شرایط جریان آزاد و مستغرق
چکیده فارسی مقاله
معمولاً برای اندازهگیری دبی آب و تنظیم سطح آب در کانالهای باز از دریچههای کشویی استفاده میشود. برآورد افت انرژی نسبی (
D
E/E
0
) و ضریب دبی (
C
d
) یک دریچه کشویی برای طراحی کانالهای باز ضروری است. با در نظر گرفتن سطح آب پایین دست، ممکن است شرایط جریان آزاد یا مستغرق رخ دهد. اگرچه برخی از تحقیقات برای تعیین
C
d
برای دریچههای کشویی انجام شده است، ولی بررسی منابع نشان میدهد که مطالعهای در مورد
D
E/E
0
وجود ندارد. دانستن
D
E/E
0
برای طراحی آبگیرها و تعیین رقوم کف کانال آبیاری ضروری است. هدف این تحقیق، تعیین
D
E/E
0
و
C
d
با استفاده از نتایج آزمایشگاهی است. نتایج نشان داد که افت انرژی را نمیتوان در سازههای آبگیر و طراحی کانال نادیده گرفت و تاثیر آنها بر رقوم کف کانالهای فرعی دریافت کننده آب از کانالهای اصلی باید در نظر گرفته شود.
افت انرژی نسبی از حداقل مقدار 271/0 تا حداکثر مقدار 604/0 تغییر نشان داد.
برای محاسبه استهلاک انرژی نسبی از روش رگرسیون چند متغیره بهره برده شد و
میانگین باقیمانده ها 004/0- بود. حداکثر و حداقل باقیمانده برای
D
E/E
0
به ترتیب 5 و 31/0- است.
برای تفکیک مرز جریان آزاد از جریان مستغرق، یک معادله ریاضی با ضریب تعیین 925/0 ارائه شد. برای تخمین ضریب دبی در جریان مستغرق،
یک معادله ریاضی بدست آمد. برای این معادله،
میانگین باقیماندهها 004/0- بود. حداکثر و حداقل باقیمانده برای ضریب دبی به ترتیب 084/0- و 116/0 است.
همچنین در این تحقیق، با استفاده از مدلهای رگرسیون غیرخطی چند متغیره، اقدام به برآورد
D
E
و
C
d
میشود که در طراحی خط پروژه کانالهای روباز مورد استفاده است.
کلیدواژههای فارسی مقاله
افت انرژی،دریچه کشویی،رگرسیون غیرخطی چندگانه،جریان مستغرق،ضریب دبی
عنوان انگلیسی
Energy loss for sluice gates under free and submerged flow conditions
چکیده انگلیسی مقاله
Sluice gates are commonly used to measure water discharge and to adjust the water level in open canals. Sluice gates can also be used at the crest of dam spillways for controlling floods. Estimation of head loss (∆E/E
0
) and discharge coefficients (
C
d
) for a sluice gate is essential for the design of open canals. Depending on the downstream water level, free or submerged flow conditions may occur. Although there have been some investigations on
C
d
for sluice gates, a comprehensive literature review shows that there are no studies of ∆E/E
0
(to the best knowledge of the authors). Knowledge of ∆E/E
0
is necessary for the design of intakes and irrigation canal inverts. This study uses the physical model of sluice gate to introduce helpful charts for energy loss estimation. Experiments were conducted in the University of Tabriz, department of water engineering. A rectangular canal with length of 12 m, width of 0.5 m and height of 0.8 m was used. Vertical slide gate was installed at the 6 m from canal inlet to permit flow become uniform. Water circulation is carried out using a submerged pump. Water is pumped in a 4.5 m head tank and then inters to canal with pipes. Water level/depth was measured with a point gauge with 0.1 mm accuracy. Discharge was measured with a calibrated rectangular sharp crested weir. Experiments were carried out with different discharges and gate opening. Results show that
∆
E
for free flow is greater than that for submerged flow conditions. Meanwhile, discharge coefficients in a free flow are greater than those under submerged flow conditions. Relative energy losses (∆E/E
0
) have a minimum value of 0.271 and a maximum value of 0.604. These high energy losses cannot be ignored in intake structures and canal-designing processes and their impact on minor canal inverts receiving water from main canals should be considered. The relative energy loss changed from the minimum value of 0.271 to the maximum value of 0.604. Multivariate regression method was used to calculate the relative energy loss and the average of the residuals was -0.004. The maximum and minimum residuals for ∆E/E
0
are 5 and -0.31, respectively. A mathematical equation with a coefficient of determination of 0.925 was presented to separate the boundary of free flow from submerged flow. To estimate the discharge coefficient in submerged flow, a mathematical equation was obtained. For this equation, the average of the residuals was -0.004. The maximum and minimum residuals for the discharge coefficient are -0.084 and 0.116, respectively. Application of multiple non-linear regression (MNR) models are presented for predicting ∆E/E
0
and
C
d
. The high energy losses cannot be ignored in intake structures and canal designing processes. Their impact on minor canal inverts receiving water from main canals should be considered. Application of MNR was presented from a simple equation to more sophisticated equations by improving regression relations in each step. The MNR method provides accurate equations for predicting performance for both ∆
E
and
C
d
.
کلیدواژههای انگلیسی مقاله
Head loss,Sluice gate,Multiple non-linear regression,Submerged flow,Discharge coefficient
نویسندگان مقاله
فرزین سلماسی | Farzin Salmasi
Department of Water Engineering, Faculty of Agriculture, University of Tabriz
گروه مهندسی آب، سازه های آبی، دانشگاه تبریز
نشانی اینترنتی
http://mcej.modares.ac.ir/browse.php?a_code=A-10-77291-2&slc_lang=fa&sid=16
فایل مقاله
فایلی برای مقاله ذخیره نشده است
کد مقاله (doi)
زبان مقاله منتشر شده
fa
موضوعات مقاله منتشر شده
نوع مقاله منتشر شده
پژوهشی اصیل (کامل)
برگشت به:
صفحه اول پایگاه
|
نسخه مرتبط
|
نشریه مرتبط
|
فهرست نشریات