این سایت در حال حاضر پشتیبانی نمی شود و امکان دارد داده های نشریات بروز نباشند
Journal of Applied Fluid Mechanics، جلد ۱۸، شماره ۱۰، صفحات ۲۴۶۵-۲۴۷۵
عنوان فارسی
چکیده فارسی مقاله
کلیدواژه‌های فارسی مقاله
عنوان انگلیسی Investigating the Effect of Grooves on the Hydraulic Parameters of a Sharp-crested Trapezoidal Side Weir
چکیده انگلیسی مقاله This study investigates the impact of groove implementation on the hydraulic performance of sharp-edged trapezoidal side weirs, focusing on discharge coefficients and shear stress behavior. The simulation processes were carried out using the VOF (Volume of fluid) methodology in combination with the RNG (Re-normalize group) model for turbulence. The validation with experimental data by comparison showed that the relative error in the range of 0.4-2.6%. It was found from the results that the discharge coefficient increases in the no-grooved model and decreases in the grooved model. The identified variation of the discharge coefficient range through different Froude numbers lies between 0.6 and 0.8, where the discharge coefficient of the no-grooved model is larger by 2.68% compared to that of the grooved model. The grooved model was more effective for lower flow rates, while the no-grooved model was more effective for higher flow rates. In all cases, in both models, the discharge coefficient increases with the Froude number, with a greater increase observed in the no-grooved configuration (19.64% higher). The research indicated that grooves significantly reduce shear stresses at the crest of the weir, reducing further damage to the structure. The variation in shear stress between the two models was most evident under high flow conditions, demonstrating the efficiency of the grooved model in reducing harmful stresses and energy dissipating.
کلیدواژه‌های انگلیسی مقاله Discharge coefficient,Froude number,Grooves,Shear stress,Supercritical flow
نویسندگان مقاله R. Daneshfaraz |
Department of Civil Engineering, Faculty of engineering, University of Maragheh, Maragheh, East Azerbaijan, Iran

E. Aminvash |
Faculty of Civil Engineering, University of Tabriz, Tabriz, East Azerbaijan, Iran

R. Omidvar |
Department of Civil Engineering, Faculty of engineering, University of Maragheh, Maragheh, East Azerbaijan, Iran

V. Süme |
Department of Civil Engineering, Faculty of Engineering and Architechture, Recep Tayyip Erdoğan University, Rize, Turkey

H. O. Marangoz |
Department of Civil Engineering, Faculty of Engineering and Architechture, Recep Tayyip Erdoğan University, Rize, Turkey

E. Yılmaz |
Department of Civil Engineering, Faculty of Engineering and Architechture, Recep Tayyip Erdoğan University, Rize, Turkey

نشانی اینترنتی https://www.jafmonline.net/article_2725_eb1cf7edd4a68dd951f5ee095fd132ec.pdf
فایل مقاله فایلی برای مقاله ذخیره نشده است
کد مقاله (doi)
زبان مقاله منتشر شده en
موضوعات مقاله منتشر شده
نوع مقاله منتشر شده
برگشت به: صفحه اول پایگاه   |   نسخه مرتبط   |   نشریه مرتبط   |   فهرست نشریات