این سایت در حال حاضر پشتیبانی نمی شود و امکان دارد داده های نشریات بروز نباشند
Journal of Sciences Islamic Republic of Iran، جلد ۲۸، شماره ۳، صفحات ۲۳۱-۲۴۱
عنوان فارسی
چکیده فارسی مقاله
کلیدواژه‌های فارسی مقاله
عنوان انگلیسی Estimating the Mechanical Properties of Travertine Building Stones Due to Salt Crystallization Using Multivariate Regression Analysis
چکیده انگلیسی مقاله Salt crystallization is one of the most powerful weathering agents that may cause a rapid change in the mechanical properties of stones, and thus limit their durability. Consequently, determining the mechanical properties of stones due to salt crystallization is important for natural building stones used in marine environmental and mild climatic conditions, which expose excessive salt crystallization cycles. In this study, multivariate regression analysis was performed for estimating the mechanical properties of travertine building stones after salt crystallization test. For this purpose, 12 travertine samples were selected and their physical and mechanical properties (density, porosity, uniaxial compressive strength, Brazilian tensile strength, and P-wave velocity) were determined. Then salt crystallization test was carried out at sodium sulfate solution (Na2SO4) up to 50 cycles and, after every 5 cycles, the uniaxial compressive strength, Brazilian tensile strength and P-wave velocity of the samples were measured. Using data analysis, regression equations were developed for estimating the mechanical properties of deteriorated samples at any cycle of the salt crystallization test. In these equations, the mechanical properties of the samples after salt crystallization were considered to be the dependent variable, which is dependent on the independent variables of the number of salt crystallization cycles, initial mechanical properties of the stones and their porosities. The validity of the equations was verified with the mechanical properties data of a researcher for salt crystallization test. The results showed that regression equations are in good accuracy for estimating the mechanical properties of stones, and thus making a rapid durability assessment. 
کلیدواژه‌های انگلیسی مقاله
نویسندگان مقاله a جمشیدی |
1department of geology, faculty of basic sciences, lorestan university, khorramabad, islamic republic of iran
سازمان اصلی تایید شده: دانشگاه لرستان (Lorestan university)

محمدرضا نیکودل | m r
2department of geology, faculty of basic sciences, tarbiat modares university, tehran, islamic republic of iran
سازمان اصلی تایید شده: دانشگاه تربیت مدرس (Tarbiat modares university)

m khamehchiyan |
2department of geology, faculty of basic sciences, tarbiat modares university, tehran, islamic republic of iran
سازمان اصلی تایید شده: دانشگاه تربیت مدرس (Tarbiat modares university)

a zalooli |
2department of geology, faculty of basic sciences, tarbiat modares university, tehran, islamic republic of iran
سازمان اصلی تایید شده: دانشگاه تربیت مدرس (Tarbiat modares university)

h یگانه فر |
3department of geology, faculty of basic sciences, payame noor university, tehran, islamic republic of iran
سازمان اصلی تایید شده: دانشگاه پیام نور تهران (Payame noor university)

نشانی اینترنتی http://jsciences.ut.ac.ir/article_62688_17609998eee079dff8ce5674638ce093.pdf
فایل مقاله اشکال در دسترسی به فایل - ./files/site1/rds_journals/513/article-513-422161.pdf
کد مقاله (doi)
زبان مقاله منتشر شده en
موضوعات مقاله منتشر شده
نوع مقاله منتشر شده
برگشت به: صفحه اول پایگاه   |   نسخه مرتبط   |   نشریه مرتبط   |   فهرست نشریات